Design of a Device for Utilizing Hazardous and Toxic Waste as Fuel For a Stove (Burner) with a PID Control System

Authors

  • Weny Findiastuti Industrial Engineering Department, University of Trunojoyo Madura
  • Ach Dafid Informatics Engineering Department, University Of Trunojoyo Madura http://orcid.org/0000-0002-6711-8367
  • Rullie Annisa Industrial Engineering Department, University of Trunojoyo Madura

DOI:

https://doi.org/10.26555/jiteki.v9i2.26179

Keywords:

Utilizing, Hazardous, Toxic, A Stove (Burner), PID

Abstract

Used oil waste is treated by spraying oil into the combustion furnace using wind from a blower. Before pouring oil into the furnace, it is necessary to manually heat it up to 300°C to burn off the fat. The controls in this study control the valve and blower to reach the desired temperature up to 800°C by utilizing a k-type thermocouple temperature sensor to detect temperature. This burner stove research uses the PID control method because it has a response that is fast enough to reach the desired temperature. The PID method is a controller that can reduce the error rate in a system to provide an output signal with a fast response, small error rate, and small overshoot. One of the contributions to this research is the importance of reducing the negative impact of hazardous and toxic waste on the environment and being an alternative solution in dealing with hazardous and toxic waste. In other conditions, this research makes an important contribution to the development of technology for processing and utilizing hazardous and toxic waste materials. Hopefully, this research will help contribute ideas and thoughts on preserving the environment and utilizing existing resources more efficiently. From the results of this study, based on the number of test results from seven tests, it can be said that the conditions are optimal because the fire produced from used oil does not contain black smoke. Meanwhile, the maximum temperature generated was 809 °C at the 73rd second, and the temperature continued to fall at the 94th second, and so on until it reached stability. These conditions indicate that the fuel speed ratio (used oil) and applied air pressure have started to improve so that the temperature is stable at 806 °C. In conclusion, the optimum test results at a flame temperature of 806 °C, the resulting flame does not produce black smoke, so the combustion of the used evaporative lubricant produces much cleaner exhaust emissions.

Downloads

Published

2023-05-09

How to Cite

[1]
W. Findiastuti, A. Dafid, and R. Annisa, “Design of a Device for Utilizing Hazardous and Toxic Waste as Fuel For a Stove (Burner) with a PID Control System”, J. Ilm. Tek. Elektro Komput. Dan Inform, vol. 9, no. 2, pp. 319–332, May 2023.

Issue

Vol. 9 No. 2 (2023): June

Section

Articles

License

Authors who publish with JITEKI agree to the following terms:

  1. Authors retain copyright and grant the journal the right of first publication with the work simultaneously licensed under a Creative Commons Attribution License (CC BY-SA 4.0) that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.

Lisensi Creative Commons

This work is licensed under a Creative Commons Attribution 4.0 International License