A new configuration of a printed diplexer designed for DCS and ISM bands

H. Setti, J. Zbitou, A. El Hamichi, A. Tribak

Abstract


This work presents a new study on the design of a microstrip diplexer configuration optimized and validated for ISM and DCS frequency bands. The achieved structure is based on microstrip technology, the goal was to design two printed bandpass filters one for ISM band and the other one for DCS frequency band.The two microstrip filters are associated by using a T-junction which permits to validate a diplexer in the frequency bands DCS-Band receiver [1.74–2 GHz] and ISM-Band transmitter [2.3–2.55 GHz]. The whole size of the final circuit is 130x50 mm2. After the validation of the proposed diplexer into simulation we have fabricated and tested it by using VNA which permits to have a good agremment between simulation and measurements.


Keywords


antenna feed; diplexer; filter and plannar structure; hairpin filter;

Full Text:

PDF


DOI: http://dx.doi.org/10.12928/telkomnika.v17i3.9991

Article Metrics

Abstract view : 183 times
PDF - 97 times

Refbacks

  • There are currently no refbacks.


Copyright (c) 2019 Universitas Ahmad Dahlan

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

TELKOMNIKA Telecommunication, Computing, Electronics and Control
ISSN: 1693-6930, e-ISSN: 2302-9293
Universitas Ahmad Dahlan, 4th Campus, 9th Floor, LPPI Room
Jl. Ringroad Selatan, Kragilan, Tamanan, Banguntapan, Bantul, Yogyakarta, Indonesia 55191
Phone: +62 (274) 563515, 511830, 379418, 371120 ext. 4902, Fax: +62 274 564604

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

View TELKOMNIKA Stats