OFET Preparation by Lithography and Thin Film Depositions Process

Sujarwata Sujarwata, Fianti Fianti, Langlang Handayani, Aji Purwinarko, Susilo Susilo

Abstract


The length of the channel OFET based thin film is determined during preparation takes place using the technique of lithography and mask during the metal deposition process. The lithography technique is the basic process steps in the manufacture of semiconductor devices. Lithography is the process of moving geometric shapes mask pattern to a thin film of material that is sensitive to light. The pattern of geometric shapes on a mask has specifications, as follows: long-distance source and drain channels varied, i.e. 100 μm, the width of the source and drain are made permanent. Bottom contact OFET structure has been created using a combination of lithography and thin film deposition processes.


Keywords


lithography; OFET; bottom contact; channel

Full Text:

PDF


DOI: http://dx.doi.org/10.12928/telkomnika.v16i1.6544

Article Metrics

Abstract view : 267 times
PDF - 256 times

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

TELKOMNIKA Telecommunication, Computing, Electronics and Control
ISSN: 1693-6930, e-ISSN: 2302-9293
Universitas Ahmad Dahlan, 4th Campus, 9th Floor, LPPI Room
Jl. Ringroad Selatan, Kragilan, Tamanan, Banguntapan, Bantul, Yogyakarta, Indonesia 55191
Phone: +62 (274) 563515, 511830, 379418, 371120 ext. 4902, Fax: +62 274 564604

View TELKOMNIKA Stats