Fuzzy Logic Implementation with MATLAB for PV-Wind Hybrid System
This paper is under in-depth investigation due to suspicion of possible plagiarism on a high similarity index
The development of hybrid renewable energy sources is vital in power generation. This study focused on design of fuzzy logic control on hybrid PV/Wind system in order to improve the speed of DC motor. The fuzzy logic control based on battery management system has been designed for effective power utilization and improvement of the DC motor speed performance. In battery management system, a control was proposed to operate the charging and discharging mode of battery during non-linear power generation. While the battery would charge whenever the renewable energy power was greater than consumer load power, the battery would discharge whenever the renewable energy power was less than the consumer load power. DC motor speed control, included the simulation, implementation of fuzzy logic controller to DC motor and comparison between PID controller and Fuzzy Logic Controller. The proposed model was simulated using Matlab environment and the results was analyzed. Finally, simulation results were evaluated and validated to determine the effectiveness of the proposed controller.
Article MetricsAbstract view : 527 times
- There are currently no refbacks.
Copyright (c) 2019 Universitas Ahmad Dahlan
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
TELKOMNIKA Telecommunication, Computing, Electronics and Control
ISSN: 1693-6930, e-ISSN: 2302-9293
Universitas Ahmad Dahlan, 4th Campus, 9th Floor, LPPI Room
Jl. Ringroad Selatan, Kragilan, Tamanan, Banguntapan, Bantul, Yogyakarta, Indonesia 55191
Phone: +62 (274) 563515, 511830, 379418, 371120 ext. 4902, Fax: +62 274 564604