Reliability Evaluation of Low-voltage Switchgear Based on Maximum Entropy Principle

Zhang Zhigang, Wang Jingqin, Wang Li, Wang Meng

Abstract


In this paper, based on the definition of two-parameter joint entropy and the maximum entropy principle, a method was proposed to determine the prior distribution by using the maximum entropy method in the reliability evaluation of low-voltage switchgear. The maximum entropy method takes kinds of priori information as different constraints. The optimal prior distribution was selected by maximizing entropy under these constraints, which not only contains the known prior information but also tries to avoid the introduction of other assumption information. Based on non-parametric bootstrap method, the hyper-parameters of prior distribution is obtained by two-order moment of prior information. Finally, with the bootstrap method, the prior distribution robustness and the posterior robustness were analyzed, and the posterior mean time between failures for the low-voltage switchgear was estimated.


Keywords


prior distribution; maximum entropy; low-voltage switchgear; reliability evaluation;

Full Text:

PDF


DOI: http://dx.doi.org/10.12928/telkomnika.v15i1.4255

Article Metrics

Abstract view : 224 times
PDF - 287 times

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

TELKOMNIKA Telecommunication, Computing, Electronics and Control
ISSN: 1693-6930, e-ISSN: 2302-9293
Universitas Ahmad Dahlan, 4th Campus, 9th Floor, LPPI Room
Jl. Ringroad Selatan, Kragilan, Tamanan, Banguntapan, Bantul, Yogyakarta, Indonesia 55191
Phone: +62 (274) 563515, 511830, 379418, 371120 ext. 4902, Fax: +62 274 564604

View TELKOMNIKA Stats