Temperature Control of the 25kW Parabolic Dish-Stirling Engine System

Liaw Geok Pheng, Mohd Ruddin Ab Ghani, Chin Kim Gan, Tole Sutikno

Abstract


This paper is under in-depth investigation due to suspicion of possible plagiarism on a high similarity index

Nowadays, even though many researchers continue to investigate and study about Parabolic Dish based on Concentration Solar Power (CSP), the findings are not conclusive and do not provide accurate evidence and proof on the potential of CSP development in Malaysia. The missing link in the Parabolic Dish (PD) Stirling Engine system modelled is the control systems, which vary the amount of working gas in the Stirling engine. The temperature of the heater in PD system which has been modelled is overheated and causes damage to the heater material, low output efficiency, high thermal losses and effect to the lifespan of the PD system. Therefore, the primary aim of this paper was to design a control system to maximize output efficiency during a normal operation by maintaining the heater/absorber temperature at the highest safe operating point and preventing excessive range of threshold to prevent damage to the heater material.


Keywords


Concentrating Solar Power (CSP), Parabolic Dish Stirling Engine system, control systems, heater, highest safe operating point



DOI: http://dx.doi.org/10.12928/telkomnika.v14i3.4055

Article Metrics

Abstract view : 523 times

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

TELKOMNIKA Telecommunication, Computing, Electronics and Control
ISSN: 1693-6930, e-ISSN: 2302-9293
Universitas Ahmad Dahlan, 4th Campus, 9th Floor, LPPI Room
Jl. Ringroad Selatan, Kragilan, Tamanan, Banguntapan, Bantul, Yogyakarta, Indonesia 55191
Phone: +62 (274) 563515, 511830, 379418, 371120 ext. 4902, Fax: +62 274 564604

View TELKOMNIKA Stats