Design and modeling of solenoid inductor integrated with FeNiCo in high frequency

Abdelhadi Namoune, Rachid Taleb, Noureddine Mansour


In this work, the design and modeling of the solenoid inductor are discussed. The layout of integrated inductors with magnetic cores and their geometrical parameters are developed. The quality factor Q and inductance value L are extracted from the S-parameters and plotted versus frequency. The effect of solenoid inductor geometry on inductance and quality factor are studied via simulation using MATLAB. The solenoid inductor geometry parameters considered are the number of turns, length of the magnetic core, the width of a magnetic core, the gap between turns, the thickness of the magnetic core, the thickness of the coil and oxide thickness of solenoid inductor. The performance of the proposed solenoid inductor integrated with FeNiCo is compared with other solenoid inductors.


high frequency; integrated; magnetic core; solenoid inductor;

Full Text:



Article Metrics

Abstract view : 0 times
PDF - 0 times


  • There are currently no refbacks.

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

TELKOMNIKA Telecommunication, Computing, Electronics and Control
ISSN: 1693-6930, e-ISSN: 2302-9293
Universitas Ahmad Dahlan, 4th Campus, 9th Floor, LPPI Room
Jl. Ringroad Selatan, Kragilan, Tamanan, Banguntapan, Bantul, Yogyakarta, Indonesia 55191
Phone: +62 (274) 563515, 511830, 379418, 371120 ext. 4902, Fax: +62 274 564604