Research on Keyhole Diameter’s Vision Measurement Based on Parallel Technology

Zhang Chuan-chuan, Zeng Zhi-qiang, Wang Jun-yuan, Du Wen-hua

Abstract


A keyhole diameter of the cartridge’s measurement based on machine vision is a part of the cartridge’s geometry measurement system, according to the system requirements, to complete the measurement within 5 seconds. A Image Collection System was constructed using computer, CCD camera, LED source, meanwhile a measurement system was compiled by C# on VS2010 platform based on machine vision. Use the Otsu algorithm to extracts the keyhole’s edge and near the pixels in order to reduce the computational Canny operator, and use parallel computing in the Canny operator to improve computing speed purposes. Use QueryPerformanceCounter timer for each module timing Canny operator, Canny operator improved computation time is reduced from the original 6s to nearly a hundred ms improved. Meet the time requirements of cartridge geometry measurement system, and other machine vision in which the project can be widely used.


Keywords


machine vision; trigger keyhole detection; edge detection; sub-pixel; threshold calculation

Full Text:

PDF


DOI: http://dx.doi.org/10.12928/telkomnika.v12i3.108

Article Metrics

Abstract view : 173 times
PDF - 136 times

Refbacks

  • There are currently no refbacks.


Copyright (c) 2014 Universitas Ahmad Dahlan

TELKOMNIKA Telecommunication, Computing, Electronics and Control
ISSN: 1693-6930, e-ISSN: 2302-9293
Universitas Ahmad Dahlan, 4th Campus, 9th Floor, LPPI Room
Jl. Ringroad Selatan, Kragilan, Tamanan, Banguntapan, Bantul, Yogyakarta, Indonesia 55191
Phone: +62 (274) 563515, 511830, 379418, 371120 ext. 4902, Fax: +62 274 564604

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

View TELKOMNIKA Stats